Regrouting Tile: The DIY Steps and How to Hire a Tiler

Removing old grout, choosing new grout, applying it, and what to check before hiring a professional.

November 11, 2026

Regrouting is a slow, careful job rather than a difficult one. Most of the time goes into removing the old grout without damaging the tiles. The rest is mixing, applying and cleaning up at the right moments.

This guide walks through the DIY process step by step and then covers what to look for if you'd rather hire a tiler. Product instructions vary, so always follow the label of the grout you buy.

Step 1: Remove the old grout

Use a manual grout saw or an oscillating tool with a grout-removal blade. Work slowly along the center of each joint, removing grout to a depth that leaves room for new grout. The new grout's instructions often say how deep the joints should be.

Wear eye protection and a well-fitting dust mask, because grout dust can contain silica, which shouldn't be inhaled. Ventilate the room and vacuum frequently. Go carefully near tile edges, since chipped tiles are hard to fix.

Step 2: Clean the joints

Vacuum all the dust and loose bits from the joints, then wipe them with a damp sponge. The joints should be clean and free of dust so the new grout bonds well.

Remove the old caulk in corners and along the tub too, since you'll want to replace it after grouting.

Step 3: Choose the right grout

The joint width and the location decide which grout fits best.

Step 4: Apply and finish

Mix only as much grout as you can use within its working time. Press it into the joints with a rubber grout float held at an angle, working diagonally across the tiles. Then scrape off excess with the float's edge.

After the time listed on the product, wipe the tiles with a damp, well-wrung sponge to shape the joints and remove residue. A light haze is common; buff it off once the grout has firmed up. Let the grout cure as directed, then recaulk the corners and seal the grout if it's a cement-based type.

When to hire a tiler

A professional is a good choice for a whole shower, large floors, epoxy grout, or any job where tiles are loose, cracked or sound hollow. These may point to problems behind the tiles that need repairing before new grout goes in.

It's also worth calling a pro if you're short on time or the tiles are expensive or hard to replace. A chipped tile can cost more to fix than the regrout itself.

What to ask before you hire

Get at least two or three written quotes for the same scope of work, so you can compare like with like.

Ask what type of grout they recommend and why, whether removing the old grout and recaulking are included, whether sealing is part of the job, how long the shower must stay out of use and whether they'll check for water damage. Check that they are licensed and insured where your state or city requires it, and look at reviews or examples of past work.

Frequently asked questions

Can I put new grout over old grout?

Generally no. A thin layer of new grout over old tends to crack and flake off. Remove the old grout to a sufficient depth first so the new grout has room to bond.

How long does it take to regrout a shower?

Removing old grout is the slow part and can take a day or more for a full shower by hand. Add time for grouting, curing, recaulking and sealing. A professional is usually faster.

Will new grout match the color of the old?

Not always. Old grout often changes color over time, so patches can stand out. For an even look, many people regrout the whole area or choose a color for everything.

Do I need to seal new grout?

Cement-based grout usually benefits from sealing once it has cured. Epoxy grout and some urethane grouts generally don't need sealing. Check the product label.

More guides