How to Replace Moldy Caulk in a Shower or Tub
Why black lines in silicone keep coming back, and how to cut out the old bead and lay a fresh one.
✅ When mold lives inside the silicone, no cleaner reaches it. Replacing the caulk is the lasting fix.
Keep readingNovember 11, 2026
Black lines along the bottom of a shower, around a tub or behind a kitchen sink are often not in the grout at all. They are in the flexible silicone caulk that seals corners and seams, and mold can grow down into it.
Bleach may lighten the surface for a while, but the stain returns because the mold underneath survives. This guide explains how to tell caulk from grout and what replacing it involves.
The key points
- Caulk is soft, grout is hard: Press with a fingernail: caulk gives a little and feels rubbery, while grout feels like stone.
- Caulk sits where surfaces meet: Corners, the joint between tub and wall and around fixtures are usually caulked, not grouted.
- Old caulk has to come out fully: New caulk laid over moldy or old caulk won't stick well and the mold can show through.
- Curing time matters: Fresh silicone needs to stay dry for the full cure time listed on the tube before the shower is used.
What you'll need
A utility knife or caulk removal tool, a plastic scraper, rubbing alcohol or a cleaner suitable for prep, clean cloths, painter's tape, a caulking gun and a tube of mold-resistant silicone sealant made for kitchens and bathrooms.
Gloves are a good idea, and keep the room ventilated, especially when cleaning with a mildew remover.
Is it a job you can do yourself?
Recaulking a tub or shower is one of the most approachable bathroom repairs. It takes patience more than skill, and the main risk is a messy bead, which you can cut out and redo.
If the caulk is hiding a bigger problem, such as soft drywall, loose tiles or water damage, call a professional before sealing it all back up.
The short version
If the black line is in soft, rubbery caulk, stop scrubbing and replace it. Remove every bit of old caulk, clean and dry the joint completely, lay a fresh bead of mold-resistant silicone and keep it dry while it cures.
Read the full guide